Tus neeg siv phau ntawv


ASSEMBLY
WARNING
Recharge only with the charger
-
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push the battery latch to the
side and squeeze the battery latch lever. Pull the
battery pack away from the machine.
WARNING
Always remove battery pack before
changing or removing accessories.
To insert the battery, slide the pack into the body of
the machine. Make sure it latches securely into place.
WARNING
recommended for this machine.
Others may be hazardous.
Selecting the Proper Cable
Cat. No. Description
48532425 19 mm x 7.6 m Inner Core Drum Cable
48532450 19 mm x 15 m Inner Core Drum Cable
48532902 19 mm x 50 mm Leader Cable
Cable Attachments for 19 mm (3/4") Cables
Cat. No. Description
48532830 Straight Auger
48532831 Funnel Auger
48532832 76 mm (3") Root Cutter
48532835 Small Opening Tool
48532836 Medium Opening Tool
48532837 76 mm (3") Grease Cutter
48532840 Head Attachment Kit
CAUTION
To prevent damage to the cable and
attachments, only use in recommended
pipe size.
Cable Installation
WARNING
To reduce the risk of injury, always
wear proper eye protection marked
to comply with AS/NZS 1337.1. Always wear leather
WARNING
Always wear leather gloves over l atex/
rubber gloves to avoid entanglement.
ment. Cable tip may be sharp. Never feed more than
30 m (100') of cable into the machine to avoid over-
for different applications. The instructions below
use. Different size and types of cables are available
loading. Remove the cable for cleaning after each
detail how to remove/install the cable manually.
NOTE: The cable feed can also be used to advance/
retrieve the cable during installation (see "Using the
Cable Feed" in the Operation section).
To manually remove the cable:
1. Move the Forward/OFF/Reverse switch to OFF O
and remove the battery pack. Ensure the cable
feed is disengaged by pressing down on the
ratchet release button.
2. Pull the cable out through the nose of the drum
until the anchor cable shows.
3. Remove the cable from the anchor cable by insert-
ing the pin key into the coupling hole and pulling
the cable away.
4. To clean or maintain cable, follow the cleaning
instructions under "Maintenance".
To manually install the cable:
1. Move the Forward/OFF/Reverse switch to OFF O.
Ensure the cable feed is disengaged by pressing
down on the cable feed quick release button.
2. Attach the cable to the anchor cable by snapping
the attachment coupler into the cable coupler.
3. Move the Forward/OFF/Reverse switch to
Forward
.
4. Use the foot pedal to start the drum.
5. Manually feed the cable into the drum.
Cable Attachment Installation
To install the attachment:
Snap the attachment coupler into the cable coupler.
Test the cable before inserting into the drain to make
To remove the attachment:
Insert the pin key into the coupling hole and pull at-
gloves over latex/rubber gloves to avoid entangle-