Specifications

3-41
CHAPTER 3 Print Output Printing an image
STEPS:
1 Check the heater temperatures.
Make sure that the CONSTANT lamps on the heater panel are lit. (See 3-22)
2 Press the [REMOTE] key.
The printer enters REMOTE mode.
The currently selected type (printing conditions) can be confirmed. (Refer to “Registering printing condi-
tions in a lump (type registration) (p.6-3)” )
3 Transmit the data from the computer.
The printing conditions that have been set for the data are displayed.
For the method of data transmission, refer to the instruction manual for the output software.
4 The printer start printing.
During printing, the length of the printed part of the media is displayed.
PRE PRT AFT
35°C 40°C 50°C
R. ∗ > [JV5-01]
∗∗.∗∗ m
PRE PRT AFT
35°C 40°C 50°C
R. ∗ +> 720x1080 .12
Bd. Vd. x1. 1L : ∗∗.∗∗ m