Specifications

CHAPTER 3 Print Output Printing an image
3-44
Automatic cleaning
Setting can be made to select whether or not to clean the heads automatically during printing.
Reliable output results are always ensured if the heads are always kept clean.
The first cleaning is performed immediately before the first printing after the printer is started. Then subse-
quent cleaning is performed every printing on the specified length of media.
When operation interval is 1000 mm (example)
STEPS:
1 Make sure that the printer is in LOCAL mode.
If it is in REMOTE mode, press the [REMOTE] key.
2 Select [SET UP] using the [FUNCTION] key and press the [ENTER] key.
When the following display is shown, press the [ENTER] key.
3 Select [AUTO CLEANING] by pressing the [] key 13 times and press the [ENTER]
key.
When [AUTO CLEANING] is to be set to ON, select ON using the [] or [] key and confirm the selection
by pressing the [ENTER] key.
Print length: 0.0 m Cleaning (1st time)
Print length: 0.8 m No cleaning
When five copies of an image 80 cm
long are printed in series, cleaning is
repeated before printing each of the
1st, 3rd, and 5th copies.
Print length: 1.6 m Cleaning (3rd time)
Print length: 1.6 m Cleaning (2nd time)
Print length: 0.8 m No cleaning
PRE PRT AFT
35°C 40°C 50°C
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
PRE PRT AFT
35°C 40°C 50°C
FUNCTION
SET UP <ENT>
PRE PRT AFT
35°C 40°C 50°C
SET UP
SELECT : TYPE 1
PRE PRT AFT
35°C 40°C 50°C
{1}
AUTO CLEANING <ent>
13
times
DECIDE = [ENTER]
DETAIL SET = [FUNC.]
[1]AUTO CLEANING
SET UP : ON