Specifications

4-27
CHAPTER 4 Daily Maintenance Cleaning the heads and their surrounding parts
Cleaning the heads and their surrounding parts
[CR.MAINTENANCE]
Take great care, especially during cleaning, not to damage the heads, which employ very precise mechanisms.
Using a cotton swab, rub off the gelatinous ink that may be adhering to the lower part of the slider and sur-
rounding parts of the heads. In doing so, never rub the nozzle part of the heads.
STEPS:
1 Make sure that the printer is in LOCAL mode, select [MAINTENANCE] using the
[FUNCTION] key, and press the [ENTER] key.
If it is in REMOTE mode, press the [REMOTE] key.
2 Select [CR.MAINTENANCE] by pressing the [] key once and press the [ENTER] key.
3 When [CARRIAGE OUT] is displayed, press the [ENTER] key.
The carriage moves to the left end of the printer body.
4 Open the left maintenance cover and the front cover.
 Be sure to wear the supplied goggle and gloves.
 The ink contains an organic solvent. If ink settles on your skin, immediately wash
it off with water. If you get ink in your eyes, immediately wash your eyes with a lot
of clean water for at least 15 minutes. In doing so, also wash the backside of eye-
lids to rinse ink away completely. Then, consult a doctor as soon as possible.
PRE PRT AFT
35°C 40°C 50°C
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
PRE PRT AFT
35°C 40°C 50°C
FUNCTION
MAINTENANCE <ENT>
MAINTENANCE
ST.MAINTENANCE <ent>
MAINTENANCE
CR.MAINTENANCE <ent>
Once
CR.MAINTENANCE
CARRIAGE OUT : ent