Specifications

CHAPTER 3 Print Output Setting the media on the printer
3-16
When the media thickness cannot be detected
There may be a case where the media thickness cannot be detected properly depending on the media.
In such a case, the media thickness must be input manually.
STEPS:
1 An error is displayed, and the carriage returns to the station.
2 Input a value of the media thickness using the [] or [] key and press the [ENTER]
key.
Initial value: 0.1 mm; Input range: 0.1 mm to 1.0 mm
3 Press the [] key twice to select ROLL. (Press the [] key twice to select LEAF.)
The carriage moves and detects the media width.
Thickness detection is also performed here if the [END] key is pressed at step 2 above.
When [MEDIA RESIDUAL] of [MAINTENANCE] function has been set to ON
STEPS:
1 Detection is completed, and the carriage returns to the station.
2 Input a value of the media length using the [] or [] key and press the [ENTER] key.
3 However, only press the [END] key when the value to be input is identical with the
previously input value.
Initial value: 50 m; Input range: 1 m to 500 m (in units of 1 m)
4 The printer returns to LOCAL mode.
PRE PRT AFT
35°C 40°C 50°C
∗∗∗∗∗ ERROR 50 ∗∗∗∗∗
THICKNESS DETECT
The thickness of the
media is inputted.
(range : 0.1 - 1.0 mm)
thickness = 0.1 mm
PRE PRT AFT
35°C 40°C 50°C
MEDIA SELECT
ROLL < > LEAF
PRE PRT AFT
35°C 40°C 50°C
Input of MediaLength
MEDIA LENGTH = 50 m