Specifications

5-5
Troubles displaying messages
5
In Case of Trouble
Message Solution
• Draw the all received data or clear the data. Then, change the settings.
( P.2-18 , P.3-34)
• Call a distributor in your district or our office.
• Check the amount of water in the hot water tank, and fill as needed.
( P.4-29)
• Head is not selected.
Select a head to be cleaned or to be filled.
• Close the front cover.
• Call a distributor in your district or our office.
• An error occurred during drawing. Pressing the key returns to
the local mode. Perform printing again.
• Position a data in the drawing area.
• Clean the wiper.
( P.4-26)
• Wiper tank is full. Excute dispose of ink in the wiper tank.
( P.4-14)
• Attach the washing cartridge.
• Replace the washing cartridge.
• Insert the washing cartridge again.
• Waste ink tank is near full. Excute dispose of ink in the waste ink tank.
( P.4-12)
• Waste ink tank is full. Excute dispose of ink in the waste ink tank.
( P.4-12)
• Clean the UV lamp filter. ( P.4-12)
• Shake the cartridge to beat ink.( P.4-22)
(At the time of SPC-0516 ink cartridge use)
• Perform white maintenance. ( P.4-21)
(At the time of SPC-0516 ink cartridge use)
<LOCAL.1>
DATA REMA I N
BATTERY EXCHANGE
WAT E R L A C K
NO HEAD SE LCT
!FRONT COVER OPEN
HD DATA S EQ
!PRINT ERROR
PRESS < ENT > KEY
ENTER
RANGE OVER XY
RANGE OVER X
RANGE OVER Y
!CLEAN WIPER
WI PER TANK FULL
<LOCAL.1>
!WashLiqu i dCar t r .NONE
<LOCAL.1>
!Wash L i qu i d END
<LOCAL.1>
!WRONG WASH CART .
! WASTE I NKTANK
! WASTE I NKTANK FUL L
MA I NT E NANCE WARN I NG
CLEAN UV LAMPF I LTER
MA I NT E NANCE WARN I NG
Shake a Ca r t r i dge
MA I NT E NANCE WARN I NG
WRoute Discharge