Specifications

Setting the print condition
3-11
3
Useful Function
Setting list
The settings of the print condition are as follows. The underlined has been set as default.
These settings can be registered on the “Type”.
Item Setting Outline
HEAD GAP(P.3-16) 0.9 to 1.2 to 2.0
Inputting the value of gap between the
head and the media.
MEDIA COMP(P.3-12) -255 to 0
to 255
Prints the pattern to adjust the media
feed.
PRINT
MODE
(P.3-14)
QUALITY
STANDARD
/
FINE/FAST
Sets the drawing quality.
MEDIA POS
ON / OFF
(When it is ON,
the media right
and the left posi-
tions)
LEFT: 1 to 700 (mm)
RIGHT: 0 to LEFT (mm)
Set the media position.
UV LEVEL(P.3-19)
HIGH
/STANDARD/
LOW/NONE/
NO PRINT H/
NO PRINT N/
NO PRINT L
Sets the UV light intensity.
UV SCAN ADD (P.3-20) OFF
/1 to 9
Sets UV irradiation at starting/ ending of
drawing.
INK LAYERS 1
to 9 Prints with layers.
COOLONG TIME (P.3-22) 0.0
to 2.0s Sets the cooling time per scan.
REFRESH LEVEL 0, 1
, 2, 3
Refreshes the ink head during drawing
or in a standby.
VACUUM
OFF/LOW/STAN-
DARD
Sets the adsorbing level for the media
to the table.
PRIORITY(P.3-21)
PRINT MODE/INK
LAYERS:
HOST
/PLOT
COOLING TIME:
HOST/PLOT
Sets the priority between PRINT
MODE, INK LAYERS and COOLING
TIME.
SETUP RESET(P.3-23) - Resets the settings.