Specifications

3-20
Sets UV irradiation at starting/ ending of drawing
Around the place where drawing has ended, UV ink may not cure due to lack of UV irradiation.
In addition, as the temperature of the board face becomes uneven around the place where drawing has
started, UV ink fixing may not be stable.
In such a case, perform setting to scan while irradiating UV depending on the status around the place where
drawing has started/ has ended. (Supported from the firmware ver.1.80)
1
When <LOCAL> is displayed, press the
key.
2
Press the key.
3
Select the type 1 to 4 with the
key, and press the key.
4
Select the [UV SCAN ADD] with the
key, and press the
key.
5
Input the left media position with the
key, and press the
key.
• Setting Value: OFF, 1 to 9
6
Input the right media position with the
key, and press the
key.
• Setting Value: OFF, 1 to 9
7
Press the key to finish.
<LOCAL . 1>
FUNCTION
FUNCT I ON
SET UP <ENT>
ENTER
SET UP
SELECT : TYPE1
ENTER
[1]
UV SCAN ADD < e n t >
ENTER
[1]UV SCAN ADD
AFTER PR I NT :OFF
ENTER
[1]UV SCAN ADD
BEFORE PR I NT : OFF
ENTER
END