User guide
Table Of Contents
- About MimioProjector
- Getting Started
- Changing the Projector Settings
- Caring for MimioProjector
- Getting Help
- General Troubleshooting
- Image Troubleshooting
- No image is displayed
- A partial, scrolling, or incorrect image is displayed
- The notebook computer display is not displaying an image
- Image is unstable or flickering
- Image has vertical flickering bar
- Image is out of focus
- Image is stretched when displaying 16:9 DVD image
- Image is too small or too large
- Image is displayed with slanted sides
- Image is reversed
- 3D Troubleshooting
- Sound Troubleshooting
- Remote Control Troubleshooting
- Contacting Mimio
- Compatibility Modes
- Technical and Environmental Information
Getting Started
Turning off the Power
To turn the projector off
1.
Press on the control panel or on the remote control.
A confirmation message is displayed on the projector screen.
2.
Press again to turn the projector off.
The Power status light turns red and blinks rapidly. The projector fans continue to run
for approximately 10 seconds to ensure that the projector cools properly.
When the system is finished cooling, the fans turn off and the Power status light turns
solid red, indicating that the projector is in standby mode.
3. Unplug the power cord.
20