User guide
Table Of Contents
- About MimioProjector
- Getting Started
- Changing the Projector Settings
- Caring for MimioProjector
- Getting Help
- General Troubleshooting
- Image Troubleshooting
- No image is displayed
- A partial, scrolling, or incorrect image is displayed
- The notebook computer display is not displaying an image
- Image is unstable or flickering
- Image has vertical flickering bar
- Image is out of focus
- Image is stretched when displaying 16:9 DVD image
- Image is too small or too large
- Image is displayed with slanted sides
- Image is reversed
- 3D Troubleshooting
- Sound Troubleshooting
- Remote Control Troubleshooting
- Contacting Mimio
- Compatibility Modes
- Technical and Environmental Information
Adjusting the General Settings
Adjusting the General Settings
You can adjust many of the general settings for your projector.
Language
Select the language to use when displaying the projector menus.
Menu Location
Select the location for the projector menu to display.
Top left
Top right
Center
Bottom left
Bottom right
Closed Caption
The following closed caption options are available:
n Off
n CC1
n CC2
n CC3
n CC4.
VGA OUT (Standby)
You can enable VGA OUT connection to display the projector image on an additional
display.
Select On to enable VGA OUT connection.
Auto Screen (12V Out)
If you are using the projector with a powered screen, you can choose to automatically lower
and raise the screen when the projector is powered on and off.
n On - the screen lowers automatically when you turn the projector power on and raises
automatically when you turn the projector power off
n Off - the screen does not lower and raise automatically when you turn the projector
power on and off
33