Setup guide

ManualsBrandsMimio ManualsOtherWireless

ireless

Setup

Guide

800-0138_01

wireless module

wireless receiver

mimio software CD

power supply (US ONLY)

12” receiver USB cable

System Requirements

• Windows® Compatible PC with a Pentium II, 400 MHz

processor minimum.

• Microsoft® Windows 98SE, Me, 2000 or XP operating system.

• 64 MB RAM minimum (128 MB RAM recommended).

• Available USB port.

* For use with mimio Xi only.

Summary of content (4 pages)

PAGE 1
wireless Setup Guide wireless module wireless receiver mimio software CD power supply (US ONLY) 12” receiver USB cable System Requirements • Windows® Compatible PC with a Pentium II, 400 MHz processor minimum. • Microsoft® Windows 98SE, Me, 2000 or XP operating system. • 64 MB RAM minimum (128 MB RAM recommended). • Available USB port. * For use with mimio Xi only.
PAGE 2
Setup Process Depress the release button and slide the module downwards to remove the linkUSB module from the mimio Xi capture bar. Insert/slide the wireless module into mimio Xi capture bar. OR Power on the device. mimio Xi can be powered by 4AA batteries or by the included AC power supply (US ONLY). Open the mimio software. Begin writing with a mimio stylus pen to use your wireless mimio Xi. Maximum wireless range is 30 feet in an open air environment.
PAGE 3
User Interface Learning Process Power indicator New page* Learn button** Duplicate page* Print page* Minimize/maximize software application* Calibrate interactive mode* Link Status Data Transmission The wireless mimio module and receiver are programmed at the factory and are packaged as a mated pair to work “out of the box” without user intervention*. They are an exclusive pair of components that will only communicate to one another.
PAGE 4
1. Power on the mimio Xi capture bar (with wireless module). 2. Plug the wireless receiver into an available USB port on your PC. 3. Using a paper clip, press the teach button on the wireless receiver to initiate the learning process. 4. Press the recessed learn button on the wireless module with the tip of a pen or the end of a paper clip to complete the learning process. 5. The Link Status LED will start flashing amber and green while the learning process is underway.