Product Manual

Product Manual for Tornado Radio Unit
25
Simply enter the new TX and Rx Frequencies and/or desired power. Enter save and follow the on screen
instructions. The next page is shown below.
A warning appears that requests that the duplexers be re-tuned, and the unit rebooted. This warning will appear
on all CCMS pages, and the transmitters will be shut down, until the unit is rebooted.
Configure RF CCMS Page
Once the unit has been rebooted a new warning will appear. It will warn that power calibration is required. Power
Calibration should be performed only after Channel 1 and 2 duplexers have been retuned. Ensure that you connect
your power meter to the Channel 1 Transmitter then select the Calibration link. Navigate through the drop-down
menu to TX Power Calibration. The Channel 1 transmitter will turn on immediately when entering the TX Power
Calibration Screen, so it is important to already have the power meter connected.
Enter New Frequencies Page
6.5 POWER CALIBRATION
The process for calibrating the transmitter power is described below. The process for calibrating the power using
CCMS is different from the process when using CLi in terms of what users can do. It is also a subject to constraints