User's Manual

Product Requirement Specification
Mimosa Confidential Page 24
Rate Limiting on WAN
Specify Upstream/Downstream WAN
rate limits in Kbps
Static routes Route Name, Destination IP, IP Subnet
Mask, Gateway IP Address
DHCP Server for LAN and
Wireless clients
Domain Name, Start IP, End IP, Lease
Time (hours: default 24 Hr, range
options 1-900 Hr)
MAC Address based static assignment
(Name, IP address, MAC Address)
Check if IP in use before assigning to
prevent duplicate IP addresses
DHCP Lease Display Table
PPPoE client
For Authentication
PPP username/password
Authentication options:
Auto/PAP/CHAP/MS-CHAP/MS-CHAPv2
PPTP Client
For VPN
PPTP Server Address
PPP username/password
Authentication options:
Auto/PAP/CHAP/MS-CHAP/MS-CHAPv2
Encryption: None, MPPE 128bit, 40 bit
MTU Setting: Default 1460
Management
and
Administration
Management ACL
Permit WebUI/SNMP from Single IP, IP
Range, Subnet mask
Management Password
Default = mimosa
Allow changing
Time Setting
Set Time and Time Zone
Set NTP server.
Web UI
Mimosa GUI similar to B5/A5
HTTP/HTPTS
Enable/Disable System Management
from LAN. This will prevent LAN side
user from changing router mode
options and disconnecting Gateway
from WAN.
Keep Monitoring/Status and Guest
config options avail from LAN
Network setting
IPv4 static IP (IP, Netmask, Gateway,
DNS1, DNS2)
DHCP client on WAN (Ethernet)
(Requested hostname, IP, Netmask,
Gateway, DNS1, DNS2)