Users Manual

Table 3. Physilog6 sensor components
Component
Function
a) Body of the
device
It includes a moulded non-flammable ABS casing which embeds the electronics
and the battery of the Physilog6 sensor device. The electronics are composed of
a microcontroller with a wireless communication unit that transmits
bidirectional information between the device and the mobile phone/tablet, the
sensors (IMU, magnetometer and barometer), a power management circuitry, a
flash memory, a LED, a button, a beeper, a RF ISM ceramic antenna and a safety
circuitry. The sensor device is powered by an internal LIB battery (lithium-ion
battery), which is IEC 62133:2012 certified.
The Physilog6 sensor device is water and dustproof according to the standard
IP64.
b) LED
It emits light indicating the different status of the sensor device;
● Charging
○ Blinking white
● Charged
○ Shining green
● Errors:
○ Blinking red:
■ Not enough battery to start a recording
■ Cannot start a recording
■ Error during a recording
■ Hardware part broken
● Recording
○ Blinking green
● Warnings:
○ Blinking yellow
■ Battery starting to be low during recording
c) Button
The button serves to perform a reset of the device in case it is not responding
normally. See section 6. Troubleshooting for more information.
d) USB-C plug
It allows the users and end-users to plug the USB cable included in the device
packaging on the one end to the Physilog6 sensor device and on the other end
either to a computer or to a compatible mobile phone charger (see
specifications on section 9 of the present document) for charging purposes.
e) Mechanical
connector for the
fixation clips
Mechanical design feature included in the Physilog6 casing and used to fit
mechanically the fixation clips into the body of the Physilog6 sensor device. The
feature is symmetrically present on both extremities of the Physilog6 casing.
ENGLISH
18/84