Users Manual

Fig 36. Physilog section - iOS Fig 37. Physilog section - Android
To change the linked Physilog6, check the serial number of your device on its backside (see Fig. 38
below). The serial number has the format PHY-06-2020-01-NNNN. Only the last four numbers (NNNN)
need to be written in the serial number field appearing on the Mobile Application screen. Click on “
” in order to pair the device. A pop up with a confirmation should appear after the device is
paired.
NOTE: Both devices can only be paired if the Bluetooth of the Mobile Phone/Tablet is enabled.
NOTE: to “wake up” the Physilog6 sensor from stand-by mode when it is not connected, lightly shake
the device to turn on its BLE (“shake up to wake up”).
Fig 38. Physilog label with the serial number surrounded by blue and
the four unique numbers to enter in the Gait Up GO mobile application
surrounded by red
If the Physilog6 sensor device’s firmware is not up to date, the Physilog screen shows the “Update
Physilog” button below the image of the sensor. See section 4.5.5 below to know more about the
Physilog6 sensor device’s firmware update.
Using the “Purchase Physilog” button it is also possible to visit the Gait Up webshop in order to buy an
additional Physilog6 sensor device. The Gait Up GO medical device uses a single Physilog6 accessory
device.
ENGLISH
39/84