Users Manual

NOTE: If you use Gait Up GO on different mobile phones / tablets and have several Physilog6 sensor
devices, it is recommended to control that the correct Physilog6 sensor device is linked to the Gait Up
GO mobile application before starting the assessment session. Once the session is started, the linked
Physilog6 can only be modified after login into the password protected part of the mobile application
again. To check the linked Physilog6, click on the button in the top right corner ( ) and check that
the indicated serial number is corresponding to the serial number of your Physilog6. To change the
linked Physilog6, go back to the Dashboard and open the “General settings” (see section 4.5.4).
Fig 47. How to start an assessment - iOS Fig 48. How to start an assessment - Android
Assign tests
By selecting “New session” the “Assign tests” section will appear. This section allows to activate or
inactivate the tests that the subject can perform during the next session.
NOTE: It is the responsibility of the medical professional to select safe and appropriate tests for each
participant and their condition.
Fig 49. Assign tests - iOS Fig 50. Assign tests - Android
Limited admin mode
While preparing the new session, the Medical Professional can select if the direct access to results is
allowed or not.
ENGLISH
43/84