User Manual

Discharge Tab Patient Setup Functions
5 - 36 0070-10-0690-01 Panorama™ Operating Instructions
5.3 Discharge Tab
The Discharge tab (shown in FIGURE 5-20) is used to discharge a patient from a patient
tile. If the required demographic information was previously entered for the patient to be
discharged, the patient will be moved to the list of retrievable patients. For additional
information regarding retrieving a patient, refer to ‘‘Retrieving Discharged Patients’’ on page
5-16.
The Discharge tab is not available at the ViewStation. Patient discharge can be performed
at the host central station, the WorkStation, or the bedside monitor. Any change in the
patient tile’s state will be communicated and changed at the host central station and bedside
monitor, if applicable.
NOTE: The host central station(s) C-LAN configuration settings and
the software installed at the remote location dictates the
functionality available for each patient tile. For additional
information, refer to ‘‘The ViewStation and the
WorkStation’’ on page 2-4.
5.3.1 Accessing the Discharge Tab
1. From the menu bar, select the Patient Setup menu button. The tabs associated with
patient setup are displayed.
2. Choose a patient tile by selecting its digital tile or waveform area.
3. Select the Discharge tab. The Discharge tab is enabled.
FIGURE 5-20 Discharge Tab
5.3.2 Discharging a Patient from the Central Station and the Bedside
Monitor
NOTE: Discharge from the bedside monitor and the central station
or WorkStation can only be performed when the central
station Discharge at Bedside button in the Unit Choices tab is
set to ON. For additional information regarding the Unit
Choices tab, refer to the “Unit Choices Tab” on page 9-50.
1. Select the tile of the patient to be discharged. Choose a patient tile by selecting its
digital data or waveform area.