User Manual

Display Tab Patient Setup Functions
5 - 42 0070-10-0690-01 Panorama™ Operating Instructions
NOTE: When using a WMTS 608 wireless bedside device with a
View 12
™
card, all 12 leads will be available in the
Parameter list, but only the waveforms for leads I, II, III,
aVR, aVL, aVF, and V1 will be displayed in the patient tile.
Digital data tiles display a minimum of three and a maximum of five parameters depending
on the parameters selected.
A digital data tile consists of three equal-size tiles. The Heart Rate (HR) parameter is always
shown in the first tile. The remaining two tiles can each be divided into two sub-tile areas. If
the associated device is a Telepack, the Battery Percentage parameter (shown in
FIGURE 5-25) will occupy one sub-tile.
FIGURE 5-25 Battery Percentage Digital Data Tile (Telepack)
Parameters occupy 1 or 2 sub-tile areas. The number of digital data parameters that can be
displayed is dependent on the type of parameters selected. For example, the NIBP parameter
uses two data tiles while the Respiration parameter uses one data tile.
FIGURE 5-26 NIBP and Respiration Digital Data Tiles
Table 5-1 shows the number of sub-tiles that each parameter occupies. For a list of the
parameters listed by monitoring device, refer to ‘‘Supported Devices’’ on page 1-4. For
additional information regarding the setup of a patient tile, refer to the ‘‘Display Tab’’ on
page 5-40.
.
TABLE 5-1
Number of Sub-tiles Occupied by a Parameter
PARAMETERS # OF SUB-TILES OCCUPIED
Heart Rate 2
NIBP 2
Respiration 1
SpO
2
1
IBP 2
Temperature 1
CO
2
2
O
2
2
N
2
O2
Agent 2