User Manual

Unit Choices Tab System Setup Functions
9 - 58 0070-10-0690-01 Panorama™ Operating Instructions
2. Select the waveform check box button to enable/disable the printing of waveforms in
strip reports. The print setup settings are changed instantaneously.
• A check mark in a waveform’s check box button indicates the waveform is selected to
print in reports when that parameter is in use.
• An empty check box button indicates the waveform is not selected and will not print in
reports.
3. To return to the Unit Choices tab, select the Previous sidebar button.
For additional information about customizing the waveform strips printed for a particular
patient, refer to the ‘‘Print Setup Tab (Patient)’’ on page 5-55.
9.14.4 Sidebar Buttons
The following sidebar buttons are used to expand the functionality of this tab.
Strip Setup
This sidebar button was previously described on page 9-57.
Previous
This sidebar button was previously described on page 9-57.
Arrhythmia
This sidebar button was previously described on page 9-55.
Settings (Telepack)
This sidebar button was previously described on page 9-56.
Normal Screen
Select the Normal Screen sidebar button to return the display to the full screen mode, and
close all tabs, message boxes, and dialog boxes.
9.14.5 Troubleshooting
This section lists some of the potential messages and issues that may occur while using the
Unit Choices tab.
MESSAGE/ISSUE * REASON SOLUTION
The System Setup menu
button is disabled.
The System Setup function is
already open on a Panorama
display and cannot be opened
on multiple displays.
Close the System Setup
function on the Panorama
display on which it is opened.
The Strip Setup sidebar
button is not displayed.
Unit Choices tab is being
viewed from a ViewStation.
If strip setup is necessary,
access the Strip Setup button
from a central station.
* Messages are shown in all bold text.