User Manual

Panorama™ Operating Instructions 0070-10-0690-01 9 - 59
System Setup Functions Wave Gain Tab (System)
9.15 Wave Gain Tab (System)
The Wave Gain tab (shown in FIGURE 9-44) is used to change the initial wave gain
settings. This tab is not available at the ViewStation or the WorkStation. Wave gain settings
are transferred from the host central station to the ViewStation and the WorkStation when the
patient tile is assigned.
For information regarding individual patient tile wave gain settings, refer to the ‘‘Wave Gain
Tab (Patient)’’ on page 5-52.
NOTE: The changes made in the Wave Gain tab (System) will apply
to newly admitted patients.
9.15.1 Accessing the Wave Gain Tab
1. From the menu bar, select the System Setup button. The first set of System Setup tabs
is displayed.
2. Follow the directions in the "Entering a Password" section on page 9-7.
3. Once the correct password has been entered, the tabs associated with the System
Setup button are displayed.
4. Select the More tab. The next set of System Setup tabs is displayed.
5. Select the Wave Gain tab. The Wave Gain tab is displayed.
FIGURE 9-44 Wave Gain Tab (System)
9.15.2 Changing the System Default Wave Gain Settings
This section outlines entering and modifying the system default wave gain settings.
1. Select the ECG mm/mV button until the desired ECG wave gain is displayed.
The settings available for the ECG wave gain include 2.5, 5.0, 10.0, 20.0, and 30.0
mm/mV. The factory default setting is 10.0 mm/mV.
2. Select the IBPx mmHg buttons until the desired IBPx wave gains is displayed. There
are four IBP buttons.
The settings available for the IBP wave gains include 0-20, 0-40, 0-80, 60-140, 0-160,
0-225,0-320, and (-10) -10 mmHg. The factory default setting is 0-320 mmHg.
NOTE: If the IBPx button(s) have been labeled at the bedside
monitor, the same label(s) will be displayed on the
individual wave gain button(s).