User Manual

Nonin SpO
2
Module Specifications Performance Specifications
16 - 30 0070-10-07XX-02 Panorama™ Operating Instructions
TABLE 16-15
GUIDANCE AND DATASCOPE CORP. DECLARATION - ELECTROMAGNETIC IMMUNITY
It is important that the Nonin SpO
2
module is used in the electromagnetic environment specified in the
following table.
Portable and mobile RF communications equipment should be used no closer to any part of the
device, including cables, than the recommended separation calculated from the equation applicable
to the frequency of the transmitter.
IMMUNITY
TEST
IEC 60601
TEST LEVEL
COMPLIANCE
LEVEL
ELECTROMAGNETIC
ENVIRONMENT - GUIDANCE
Conducted RF
IEC 61000-4-6
3 Vrms
150 kHz to 80
MHz
3 V Recommended separation
distance
d = 1.17 x
Radiated RF
IEC 61000-4-3
3 V/m
80 MHz to 2.5
GHz
3 V/m
d = 1.17 x 80 MHz to 800
MHz
d = 2.33 x 80 MHz to 2.5 GHz
Where P is the maximum output power
rating of the transmitter in watts (W)
according to the transmitter
manufacturer and d is the recommended
separation distance in meters (m).
Field strengths from fixed RF transmitters,
as determined by an electromagnetic
site survey,
a
should be less than the
compliance level in each frequency
range.
b
Interference may occur in the
vicinity of equipment marked
with the following symbol:
NOTE: At 80 MHz and 800 MHz, the higher frequency range
applies.
NOTE: The EMC guidelines in Table 16-15 on page 16-30 may
not apply in all situations. Electromagnetic propagation is
affected by absorption and reflection from structures,
objects and people.
a Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and
land mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted
theoretically with accuracy. To assess the electromagnetic environment, due to fixed RF transmitters, an
electromagnetic site survey should be considered. If the measured field strength where the Nonin SpO
2
module is used exceeds the applicable RF compliance level, the Nonin SpO
2
module should be observed to
verify normal operation. If abnormal performance is observed, additional measures may be necessary,
such as reorienting or relocating the Nonin SpO
2
module.
b Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3 V/m.
P
P
P