User Manual

Panorama™ Operating Instructions 0070-10-0690-01 2 - 21
Getting Started Quick Reference Guide
•The Bedside and Panorama Standby button places the patient in Standby at the
Panorama Central Station and the bedside monitor.
NOTE: The Bedside and Panorama Standby button is not available
when using a Telepack device.
4. Select a patient’s Standby location.
a. Select a location from the patient location list
b. Choose the Select button
To activate Standby mode at the bedside monitor:
• Select the STANDBY button on the front of the bedside monitor. This method places both
the bedside monitor and the Panorama Central Station in Standby mode.
To remove a patient from the Standby mode at the Panorama Central Station or the
WorkStation:
1. Select the Patient Setup menu button.
2. Choose a patient tile by selecting its digital data or waveform area.
3. Select the Standby tab.
4. Select the Resume Monitoring button. Monitoring is resumed at the Panorama
Central Station.
To remove a patient from the Standby mode at the Panorama Central Station and the
bedside monitor:
• Select the STANDBY button on the front panel of the bedside monitor. Monitoring
resumes at the Panorama Central Station and the bedside monitor.
For additional information on Standby, refer to the "Standby Tab’’ on page 5-49.
2.5.3 Discharge
The discharge function discharges a patient from a patient tile and resets the Panorama
Central Station for the next patient. This tab is available at the WorkStation.
To discharge a patient:
1. Select the Patient Setup menu button.
2. Choose a patient tile by selecting its digital data or waveform area.
3. Select the Discharge tab.
4. Select the Bedside and Panorama Discharge button.