User's Manual

Powering On the Unit Getting Started
3 - 8 TM80/TM70 Telemetry Monitor Operator’s Manual
4. Press down the battery frame until it closes firmly, as indicated by the arrow in the
following figure.
The TM80/TM70 is automatically powered on after the batteries are installed.
3.5 Powering On the Unit
Press the key to turn on the TM80/TM70. The cyan alarm light will momentarily turn
on to indicate that the device is starting. The TM80/TM70 performs a self-test during
startup. The alarm light flashes red, yellow, and cyan in turn, and then off. This indicates
that the alarm system functions correctly.
Upon powering up, there are two situations:
■ If the TM80/TM70 is turned on at first time, the device will request you to configure
first time startup.
■ If the TM80/TM70 is turned on next time, the device will prompt whether it is a
new patient. Select [Ye s ] or [No] as desired. If the device is a lock mode, a passcode
is required.