User manual

Field Guide

Pinpointing the Target

1 Once the approximate target location is known,

move the coil to one side of that location and press

Pinpoint.

2 Sweep the coil slowly over the target location.

Note: Keep the coil parallel to the ground while

Pinpointing.

3 Taking note of the response, reduce the span

of each successive pass of the coil until you are

condent of the location of the target. Make a

mental note of the position, or mark a line on the

soil with your shoe or a digging tool.

4 Move to one side so that you can pass the coil over

the target at right angles to your initial direction.

5 Repeating the above steps in the new direction will

give an exact location to dig.

Pinpoint

Pattern

Edit

Combine

Digital

QuickMask

Minelab Modes

Mode 1 – Coins Mode 3 – Beach

Mode 2 – High Trash Mode 4 – Relics

– This dialogue box will appear, allowing

you to conrm whether or not you wish to

load the QuickMask Discrimination Pattern

into either the Pattern or Digital Screen.

Detect

Pattern Digital

QuickMask

Detect Detect

QuickMask QuickMask

PAGE 1
Pinpointing the Target 1 Once the approximate target location is known, move the coil to one side of that location and press Pinpoint. Edit 2 Sweep the coil slowly over the target location. Pattern Field Guide Pattern Digital Detect Note: Keep the coil parallel to the ground while Pinpointing. Combine 3 Taking note of the response, reduce the span of each successive pass of the coil until you are confident of the location of the target.
PAGE 2
Power Backlight Left Shift Right Shift FE-CO Numbers Depth Gauge Press to turn E-Trac On/Off. The Ferrous and Conductive properties of a detected target. Sensitivity Gauge Press to turn the Backlight On/Off. QuickMask Press to access QuickMask. Noise Cancel Starts an Automatic Noise Cancel. Smartfind Window Displays the active Discrimination Pattern. Accept/Reject Pressing in the Detection Screens accepts or rejects the detected target.