User manual
CTX 3030 Audio Options
KNOWLEDGE BASE ARTICLE | KBA 21-2 Page 4
Wi-Stream Technology
Wi-Stream wireless technology is used to communicate between the CTX 3030 and the WM 10 Wireless Audio Module. This new
technology has been developed especially for the CTX 3030 to provide no perceivable delay ( less than 10 ms). This is important for
detector users as lags in the audio response make it difficult to locate and pinpoint targets.
Wi-Stream does not transmit audio data, like other technologies (e.g. Bluetooth). Instead packets of data are sent to the WM 10 and
then converted to an audio signal within the WM 10. This increases the speed of signals and greatly reduces the effects of electrical
noise.
The Wi-Stream radio signal is transmitted from the control panel . Therefore, if the control panel is submerged underwater the radio
signal will be blocked by the water and no target signals will be produced from the WM 10.
Wi-Stream Specications
Frequency: 2.4 GHz ISM band (same band as Bluetooth)
Power: <2 mW - transmit from both detector control panel and WM 10
Channels: 14
Connection type: Point-to-point - only one WM 10 can be paired with the detector at a time
Wireless compliance standards: ETSI EN 300 440-1: V1.6.1 (2010-08) Electromagnetic Compatibility with Radio Spectrum Matters
and ETSI EN 300 440-2: V1.3.1 (2008-11) Electromagnetic Compatibility with Radio Spectrum Matters