Instruction manual
Regardless of which coil is your coil of choice, make sure you center
the target under the coil before working the coil toward you. And
remember, for this method to work eectively, you must have all
notches set to accept. Rejected notches create target blanking and
audio tones will not be provided for those notch segments. And since all
ferrous targets produce the same sound in anything less than multiple
tone mode, you wouldn’t hear harmonic (blended) low tones if you are
using one, two, three or four tone modes either. You must use multiple
tone audio mode with zero discrimination for this procedure to work
properly.
Next time you’re out hunting a site where deeply buried iron is giving
you the “wrap around eect”, give this procedure a try. If you hunt the
kind of places I hunt, you‘ll nd using this procedure will result in your
digging a lot less iron.
Randy Horton (Digger)
You’ll never know for sure... unless you dig it!
www.minelab.com/treasure-talk
Treasure Talk
42Understanding your X-TERRA - Discrimination