User's Manual

Personal Node User Manual Section 3 About the Personal Node
10 / 70
Rev: 1.1
©
c
Minete
01
2
9
Trax solution. Apart from charging and checking the device is OK when removing it from the dock,
wearing the Personal Node on a belt or harness is all that is required.
3.3 Working with SafeDetect™ (stand-alone)
SafeDetect provides fast and accurate proximity detection between vehicles and pedestrians. Each
proximity event represents a nearby asset (vehicle or person). SafeDetect assesses each proximity
event based on the configuration and triggers simple, expressive visual cues and audible alarms to
vehicle operators using an In-Vehicle PC and pedestrians wearing a Personal Node.
SafeDetect does not replace Vehicle Operator or Pedestrian vigilance. It is the
responsibility of the Vehicle Operator and Pedestrians to understand, acknowledge
and act on the warnings per site HSE policy and standard operating procedures.
Although SafeDetect provides audible and visible warnings, responsibility for any intervention or action
remains with the Vehicle Operators and Pedestrians.
The system only detects vehicles and pedestrians fitted with SafeDetect nodes. Vehicles and
pedestrians not fitted with nodes will not be detected by the system.
3.4 Configuration via MineOffice
MineOffice is the central management application for all Minetec software and hardware products.
Accessible via a web interface, MineOffice is used to set-up and configure Minetec hardware as well
as all desktop and mobile apps within the Minetec software suite. As appropriate, firmware and
software updates can be performed remotely when within network coverage. MineOffice also enables
centralised monitoring and diagnostics of Minetec products.
Initial configuration of MineOffice is handled by Minetec during deployment of the solution.
MineOffice is used for device administration and configuration. MineOffice stores asset, maps (Trax
only) and configuration details, including:
• Asset Register, used to auto populate personnel and vehicle names and icons. (All solutions).
• Geometry service, contains the map for each location (Trax only)
• Configuration, contains the underlying configuration for each solution.
More information about:
• Personal Node configuration, refer to the MineOffice User Manual.
SafeDetect does not and will not stop any vehicles.
Administrative Functions requires an Administrator password.