User's Manual

Personal Node User Manual Section 5 Everyday operation
32 / 70
Rev: 1.1
©
c
Minete
01
2
9
5.2 Operate a Personal Node
The following procedures are performed anytime a Personal Node is required to be used by
personnel or visitors entering an area with vehicular hazards. For personnel, these procedures are
typically at the start and end of the shift.
Procedure 1 Charging a Personal Node
A user performs this procedure at the end of a shift or when a Personal Node needs charging.
Charging and full charge are indicated by the integrated Charge LED on each Personal Node.
Refer to About the Personal Node Charging Dock on page 36 for details of the charging dock.
Step
Action/Response
Comments
1) Check dock
has power.
Ensure the Personal Node Charging Dock is
powered on and the large LED is solid green
About the Personal Node
Charging Dock on page 36
A running fan is audible in a
typical office environment.
2) Remove
Personal
Node
Remove the Personal Node from your belt or
harness.
3) Insert into
dock and
confirm
charging.
1) Place the node in the dock ensuring it
is firmly and positively seated.
2) Confirm that the Charge LED is solid
red.
A red Charge LED indicates the
device is still charging.
When the Charge LED is green
the device is fully charged.
Procedure 2 Using a Personal Node
This procedure covers a user obtaining a Personal Node when entering site operations. Exact actions
and responses in the operation of the Personal Node are defined by the on-site operational and HSE
policies and procedures communicated to you at training.
Step
Action/Response
Comments
Personal Nodes should be charged when not in use.