User's Manual

Personal Node User Manual Section 5 Everyday operation
33 / 70
Rev: 1.1
©
c
Minete
01
2
9
1) Obtain a
Personal Node.
Remove a Personal Node from
the dock by selecting a device
with a solid green LED.
A Personal Node automatically turns on
when removed from the dock.
2) Check the
Personal Node
is working.
Confirm the Start-up sequence
detailed on page 23.
If the pattern is incorrect, refer
to Personal Node
troubleshooting on page 57.
1) The Status and Charge LEDs glow
blue and the two side LEDs glow
red.
2) All LEDs flash red three times.
3) The unit beeps three times.
4) The Status LED starts to flash green
(once every 2 seconds) indicating
the device is ready to use.
3) Place node on
you belt or
harness.
Attach the Personal Node by
passing one side of your belt
through the metal bracket the
back of the unit.
The Personal Node is ready for
proximity event detection (i.e. to
detect, and be detected by, vehicles)
An optional swivel belt clip is available
that allows a Personal Node to attach
directly to a belt without having to
unbuckle the belt and pass it through the
bracket. Contact Minetec for further
details.
4) Enter site
operations.
Pay attention to any visible or
audible patterns.
For example:
• Proximity event detected in
SafeDetect.
• Low Battery voltage, etc.
Table 9 Regular operating patterns on
page 24.
Table 10 Irregular operating patterns on
page 26.
5) Respond to any
patterns
(SafeDetect
only)
Take note of, and respond to,
any visible or audible patterns.
A momentary press and release
of the button will, for example,
mute a proximity alarm.
This step only applies when using SafeDetect.
Users are to respond to patterns in line
with on-site Operational and HSE policies
and procedures.
6) Return the
Personal Node.
When finished with the Personal
Node, return it to the Charging
Dock.
Procedure 1 Charging a Personal Node on
page 30.