User's Manual

Personal Node User Manual Section 5 Everyday operation
36 / 70
Rev: 1.1
©
c
Minete
01
2
9
Use this guide to manually cancel the Broadcast Me function.
Step
Action/Response
Pattern/Comments
1) Person cancels
IVD mode.
Press the button twice within two
seconds. IVD mode is cancelled and the
STOP zone alarm annunciates.
The Personal Node alarm annunciates
as the user is still very close to the
vehicle.
5.4 Use Broadcast Me alert
A Personal Node user can activate the Broadcast Me function.
This function continuously broadcasts the unique ID of the Personal Node (eg PN007) and when the
broadcast is received by a nearby vehicle, the In-Vehicle PC shows a coloured flag next to the
Personal Node's ID in the detections list and an audible alert is sounded. See About Broadcast Me on
page 21 for details.
Procedure 6 Activating the Broadcast Me function
Use this guide to activate the Broadcast Me function on the Personal Node. This function operates in
conjunction with IVD mode so can be used by users and Vehicle Operators with a Personal Node.
Step
Action/Response
Pattern/Comments
1) Person
activates
Broadcast Me
function
Press and hold the device button for two
seconds. The Personal Node does the following:
• All LEDs flash white.
• An audible alarm annunciates.
• Broadcast Me function signal broadcasts
2) Vehicle
Operator
Responds to
the alarm
Respond accordingly.
Vehicle Operators are to
respond to Broadcast Me
function in line with on-site
Operational and HSE
policies and procedures.
Procedure 7 Cancelling Broadcast Me function
Use this guide to cancel the Broadcast Me function.
Note if
Broadcast Me
is activated while in IVD mode, the
Broadcast Me
function takes
precedence.