Installation Guide

Wi-Fi WASP Infrastructure Installation Guide
Installation Guide
Section 4 Installing Infrastructure
Rev: 1 13 / 28
© Minetec 2019
Figure 4 Access Point LEDs
4.2 Wi-Fi WASP™ Bridge
Bridges are installed in known, and fixed locations around a mine. See Figure 5 on page 14. Bridges
communicate with Mobile Nodes, installed on vehicles, and Access Points installed throughout the
mine site.
Each Bridge comes with a right-angled mounting bracket, pre-bolted to the unit. This allows for
numerous mounting options, depending specific site conditions and policies. The mounting options
are:
• Bolting directly to the backs or wall using a custom auxiliary bracket.
• Attaching with stainless steel cable ties to mesh (Figure 7 on page 15
).
• Using a Threaded Rod to bolt to the backs or wall (Figure 8 on page 15).
When considering mounting options, ensure space between the Bridge and the wall to
allow the power cable to be connected.
Device label
window
Network
LED
System LED
Power
LED
3x antenna connectors
2
x Ethernet
ports per side
2
x DC power
connectors
per side