Installation Guide

Wi-Fi WASP Infrastructure Installation Guide Installation
Guide
Rev: 1 ii
© Minetec 2019
Responsible use
This document describes a Minetec system, including how to operate or troubleshoot hardware
and/or software. The procedures and guidelines are not prescriptive and do not include operational
and safety processes that may apply at your site. As such, responsible use of the procedures and/or
guidelines in this document is only achieved by aligning with and/or being incorporated within the
Contractor's own operational and HSE policies, guidelines and procedures.
Safety precautions
To prevent damage to the devices product and to ensure the correct operations, please read these
precaution statements before installing or troubleshooting any devices.
CAUTION
Do not attempt to service any device unless both qualified and authorised my Minetec
in writing, and as indicated in this document.
• If applicable, disconnect devices from all power sources before cleaning. Do not use liquid or
spray detergents for cleaning. Use a soft, lint-free cloth to wipe screens and a damp cloth to wipe
the exterior of any device. Do not use paper towels to clean the screen.
• Minimise the exposure of devices to ultraviolet light for extended periods (eg direct sunlight) as
this can damage the device surfaces (eg make them more brittle).
• Keep the device away from excessive moisture and extreme temperatures.
• Do not subject the device to sudden and severe temperature and/or humidity changes. This
could cause moisture condensation inside the unit, which could damage the device. In the event
of moisture condensation, allow the device to dry out completely before use.
General safety
To ensure your own personal safety and prevent electrical damage and/or fire, please read these
safety statements before installing any devices. Use extreme care and caution when installing or
removing devices.
CAUTION
Do not attempt to service any device unless you are experienced, qualified and
authorised by Minetec in writing, and as indicated in this document.
Always use care when handling or operating Minetec devices.
For all devices:
• Dropping a device or letting it fall could cause damage resulting in a potential electrical or fire
hazard and/or voiding the warranty.
• Some devices may get hot in use and could pose a potential fire or burn hazard. Do not place
anything on top of the device or drop objects on the device.
• Make sure the voltage of the power source is correct before connecting any device to the power
source. The incorrect voltage may pose an electrical and or fire hazard.
• To prevent damage, fire and/or electrical shock, note all cautions or warnings on a device.
• Never pour any liquid on to or into any device. Depending on the device, this may cause damage
resulting in fire and/or electrical shock.
• For product warranty, safety and performance reasons, only authorised and qualified service
personnel should open any device.