Installation Guide

Wi-Fi WASP Infrastructure Installation Guide
Installation Guide
Section 5 Troubleshooting
Rev: 1 25 / 28
© Minetec 2019
5.3 ICT Cabinet
This table only covers the installation and mounting of an ICT Cabinet.
Check for Test Action for failed test
1) Physical
damage.
Visually inspect the device for obvious physical
damage and ensure that it appears to be in
good physical order.
Contact your supervisor to
arrange a replacement
using the RMA Procedure
on page 26.
2) Environmental
problems.
Is there any water around or under the power
connector?
Dry out connections and
mitigate further water
intrusion.
3) Power supply.
Is the required power supply available?
Perform power source
troubleshooting.
Is the power cable free of damage? Replace cable.
4) Unresolved.
If the problem persists after performing the
above tests and actions.
Contact your supervisor to
arrange a replacement
using the RMA Procedure
on page 26.