Owner`s manual
Table Of Contents
- At a glance
- Controls
- Opening and closing
- Vehicle equipment
- Remote control/key
- Personal Profile
- Central locking system
- Opening and closing: from the outside
- Opening and closing: from the inside
- Tailgate
- Comfort Access
- Alarm system
- Power windows
- MINI Convertible: convertible top with integrated sliding sunroof
- MINI Convertible: wind deflector
- MINI Roadster: manual convertible top
- MINI Roadster: semi-automatic convertible top
- MINI Roadster: wind deflector
- Adjusting
- Transporting children safely
- Driving
- Displays
- Lamps
- Safety
- Driving stability control systems
- Driving comfort
- Climate
- Interior equipment
- Storage compartments
- Opening and closing
- Driving tips
- Navigation
- Entertainment
- Communication
- Mobility
- Reference
the battery, or to the engine or body
ground of the vehicle to be started.
Body ground:
Starting the engine
Never use spray fluids to start the engine.
1.
Start the engine of the assisting vehicle and
let it run for several minutes at a slightly in‐
creased idle speed.
2. Start the engine of the vehicle being started
in the usual way.
If the first starting attempt is not successful,
wait a few minutes before making another
attempt in order to allow the discharged
battery to recharge.
3. Let both engines run for several minutes.
4. Disconnect the jumper cables in the reverse
order.
Check the battery and recharge if necessary.
Tow-starting and towing
Notes
Observe applicable laws and regulations
Observe applicable laws and regulations
for tow-starting and towing.◀
No additional passengers
Do not transport any passengers other
than the driver in a vehicle that is being
towed.◀
Using a tow fitting
The screw-in tow fitting must always be carried
in the vehicle. It can be screwed in at the front
or rear of the MINI.
Tow fitting, information on use
▷ Use only the tow fitting provided with
the vehicle and screw it all the way in.
▷ Use the tow fitting for towing on paved
roads only.
▷ Avoid lateral loading of the tow fitting, e.g.,
do not lift the vehicle by the tow fitting.
Otherwise, damage to the tow fitting and the
vehicle can occur.◀
Access to the screw thread
Push out the tow fitting cover at the appropri‐
ate recess in the bumper.
Front
Rear
John Cooper Works with aerodynamic bumper:
Pull out the tow fitting cover in the bumper in
the lower section, arrow.
Seite 256
Mobility
Breakdown assistance
256
Online Edition for Part no. 01 40 2 919 017 - II/13