Owner`s manual

3. Remove the blue lock (1) from radio harness by

releasing tab and sliding upwards, then remove

following terminals (2) using AMP terminal

removal tool p/n 611 134:

Pin 12- Ground Connector (Brown)

Pin 15- Battery +12V (Red/Brown)

Pin 16- Ignition +12V (Violet/Blue)

Note: wire colors may vary depending on

vehicle production changes.

4. Cut original terminals off of 3 wires (1) removed

from locations 12, 15 &16. Cut wire as close as

possible to existing terminal to maintain wire

length.

5. Strip 1/8” of wire shielding from 3 wires.

6. Using BMW terminal crimping tool p/n 408 449 or

Snap-on PWC47 crimp new female bullet

connectors included in kit onto each of the wires

from previous step.

7. Insert the 3 terminals (4) into 3-pin connector (5)

included with the harness as follows:

IMPORTANT Pin 1 is identified by the

straight edge of the connector

Pin 1- Battery +12V (Red/Brown)

Pin 2- Ignition +12V (Violet/Blue)

Pin 3- Ground (Brown)

Note: wire colors may vary depending on

vehicle production changes.

8. Insert 5 wires from the hands-free kit harness (1)

into the radio connector (2).

From Harness

To Radio

Connector Pin

Yellow (BAT) 15

Red (IGN) 16

Black (GND) 12

Violet (Mute) 10

Green (Tel ON) 11

9. Reinsert blue lock into radio harness connector.

Install Manual P/N 01 29 0 309 308