Owner`s manual

10. Insert black 12-pin connector from hands-free kit

harness (1) into lower right section of radio

connector (2).

11. Connect male & female 3-pin connectors (3).

Note:

On vehicles equipped with Navigation

and/or AUX Input the 12-pin connector (1) is

already included in radio harness. It will be

necessary to remove pins 6 & 12 from the

hands-free kit harness 12-pin connector and

insert them into the appropriate slots of the

existing 12-pin connector

12. Remove 2 upper screws to bulkhead (1).

13. Loosen 2 lower screws (2) to expose ¼” of thread.

14. Slide the 2 lower slots of the module bracket (1)

onto 2 screws (2) loosened previously.

15. Install module bracket to bulkhead using 2 upper

screws (3) removed previously. Tighten all 4

screws.

16. Route hands-free kit wiring harness up through

radio cavity to bracket mounting location.

17. Insert and secure 18-pin connector (1) into hands-

free kit module (2).

18. Secure control module (2) to module-bracket

using 2 - M4x16 Screws (3).

NOTE: A right-angle screwdriver is recommended

to install screws into bracket.

Install Manual P/N 01 29 0 309 308