Owner`s manual

5
19. Remove microphone cover from center overhead
location.
20. Remove left A-pillar cover, if not already removed.
(Refer to TIS RA 51 43 201)
IMPORTANT: The A-Pillar cover is a one time
use component and MUST BE REPLACED
WITH A NEW PART ONCE REMOVED.
21. Route microphone harness with black 3-pin
connector (1) from 18-pin connector of hands-free
kit harness (2) along underside of dash, up
through left-hand A-pillar (
along windshield) and
to microphone mount location in center overhead
(3). Secure cable as necessary to existing vehicle
wiring.
22.
IMPORTANT: When routing microphone harness
(1) along the left A-Pillar insure that the harness is
routed along the windshield. The harness should
not be routed in a manner that will cause it to
interfere with the HPS, secure harness along the
A-pillar close to the windshield using plastic ties to
secure it to the harness running up the A-pillar.
CAUTION: An improperly routed cable may
interfere with HPS and cause serious injury
in a collision.
23. Replace any components damaged by removal
of A-pillar cover before the new A-pillar cover
is reinstalled.
24. Insert Microphone (1) into Microphone cover (2).
NOTE: Arrow on microphone should point
towards front of vehicle.
25. Insert microphone connector (3) into microphone
and install microphone in overhead console.
Note: On vehicles equipped with a sunroof the
location of the sunroof switch and microphone can
be switched in order to place the microphone
closer to the driver.
26. Reinstall radio using 4 original mounting screws.
27. Adhere strips of mounting tape (1) to top and
bottom positions of button bracket (2). Trim
excess tape as necessary.
28. Mount controller (3) to button bracket (2) with
provided adhesive tape (1). Be sure to properly
align controller to bracket before adhering.
Install Manual P/N 01 29 0 309 308