Instruction manual

SAFETY PRECAUTIONS
1. COMPRESSED AIR IS DANGEROUS, NEVER direct a jet of air at people or
animals, and NEVER discharge compressed air against the skin.
2. Electrical or mechanical repairs should only be carried out by a qualified
engineer. If problems occur, contact your Clarke dealer.
3. Before carrying out any maintenance, ensure the compressor is disconnected
from the mains supply
4. DO NOT operate in wet or damp conditions. Keep the machine dry at all
times. Similarly, a clean atmosphere will ensure efficient operation. Do not
use in dusty or otherwise dirty locations.
5. Some of the metal parts can become quite hot during operation. Take care
not to touch these until the machine has cooled down.
6. ALWAYS ensure that there is adequate ventilation when spraying and keep
clear of any possible source of ignition.
7. Protect yourself. Think carefully about any potential hazards which may be
created by using the compressor and use the appropriate protection. e.g.
goggles will protect your eyes from flying particles. Face masks will protect
you against paint spray and/or fumes.
8. Before spraying any material always consult paint manufacturers instructions
for safety and usage.
9. Do not exert any strain on electrical cables and ensure that air hoses are not
tangled or wrapped around machinery etc.
10. Before disconnecting air hoses or other equipment from your compressor
ensure that the compressor is switched off.
11. Make sure that children and animals are kept well away from the compressor
and any equipment attached to it.
12. Always ensure that all individuals using the compressor have read and fully
understand the Operating Instructions supplied.
13. Ensure that any equipment or tool used in conjunction with your compressor,
has a safety working pressure exceeding that of the machine.
14. Always place the compressor on a level surfacer wherever possible.
15. It is not advisable to carry the compressor when spraying.
16. DO NOT allow the compressor to run unnecessarily .. .switch it OFF when the
spraying tool is not being used.. .even for a short time.
WARNING!
As with all machinery, there are certain hazards involved with their operation
and use. Exercising respect and caution will considerably lessen the risk of
personal injury. However, if normal safety precautions are overlooked, or
ignored, personal injury to the operator, or damage to property may result. It is
in your own interest to read and pay attention to the following rules:
4