Instruction manual

IV. BUILDING AND INSTALLING THE RADIO SUPPORT ASSEMBLY

Bags Required: #4A, #4B

Tools or Materials Required:

M2.0 and 2.5 Allen tools

M5.5 flat wrench (7/32@)

Assemble and Install the Radio Support

Parts Required: Bag #

4 #0019 M3 hex locknuts 4B

2 #0064 M3x8 button head bolts 4B

1 #0089 M3x10 flat hex head bolt 4B

2 #0840-31 M3x16 button head bolts 4B

1 #106-41 Canopy Standoff 4B

1 #115-24 Horizontal channel 4A

1 #123-32 Tank plate 4A

1 #115-28 Radio/battery plate 4A

1 #115-30 16.0x305.0mm red Velcro 4A

2 #115-32 Plastic spacers 4B

Refer to Drawings #4A

and #4B.

A. Select the #115-24 Horizontal Channel. Being a Au-shaped@ channel, we=ll consider the bottom to be the flat

side. Select the #123-32 Tank Plate. Two-sided adhesive tape has already been applied. This side will be the

Abottom@ side. Review Drawing #4A to determine what is Afront@ and Arear@ for each part. Select two #0064

M3x8 Button Head Bolts and two #0019 M3 Hex Locknuts. The two bolts should enter the tank plate from

the bottom (Atwo-sided adhesive tape side@) up through the flat side of the #115-24 Horizontal Channel,

followed by two #0019 M3 Hex Locknuts from above. Tighten both securely.