Instruction manual

21
B. Select the #115-28 Radio/battery Plate, the #115-30 Velcro Strip, two #0840-31 M3x16 Button Head Bolts,
two #115-32 Plastic Spacers and two #0019 M3 Hex Locknuts. At this time, it is suggested to make a
determination of final battery position for correct model C.G. Two positions are possible on the radio/battery
plate. In general, you=ll want to locate the plate in the forward position using the most narrow bolt spacing.
C. The #115-28 radio/battery plate is reversible so either side can be considered the top. Holding the Velcro
strip firmly against the bottom of the radio/battery plate (with the three holes aligned) insert two #0840-31
M3x16 button head bolts from the topside of the plate and through the Velcro strip. Select two #115-32
plastic blocks and slide each onto an exposed bolt. Position this assembly onto the front end of the #115-24
horizontal channel (the side opposite
the previously installed tank plate and the open part of the Au-channel@
upward). The plastic blocks will sit inside the open side of the channel. Install and tighten two #0019 M3 hex
locknuts onto the bolts and against the bottom Aflat@ side of the channel.
D. Select one #106-41 canopy stand-off and one #0089 M3x10 flat hex head bolt. The sides of the #115-24
horizontal channel each have three holes. Two are with PEM nuts and one, at approximately center, is open.
From inside the u-channel, insert one #0089 M3x10 flat hex head bolt so it protrudes out of the Aleft side@
open hole. Examine the left main frame. In the lower front section, the left frame has three holes which
correspond to those on the left side of the horizontal channel. Apply Blue Loctite to the previously inserted
#0089 bolt and insert it with the horizontal channel into the furthermost forward hole in the main frame. From
outside the main frame, install one #106-41 canopy stand-off onto the #0089 bolt. Align the remaining two
holes and tighten the bolt into the stand-off using a flat wrench.