Instruction manual

V. INSTALLING THE RIGHT MAIN FRAME, BELL CRANKS AND GYRO BRACKETS

Bags Required: #5A through #5E

Tools or Materials Required:

M1.5, 2.5 Allen tools

M5.5 and 7.0 (5/32@ and 7/32@) flat wrenches

Small Phillips screwdriver

Slow Cyanoacrylate glue (CA)

Step 1: Installing the Rear Elevator Bell Crank

Parts required: Bag #

2 #0003 M3 Washer 5B

2 #0107 M3 x 6 Threaded Balls 5B

1 #122-29 Rear Elevator Bell Crank 5B

1 #0099 M3 x 30 Phillips Bolt 5B

1 #0019-1 M3 Locknut (special low profile) 5B

1 #0597-1 M3 x 3.19 x 4.75 Brass Spacer 5B

1 #0597-2 M3 x 3.42 x 4.75 Brass Spacer 5B

1 #123-30 G-10 Right Main Frame 5A

1 #122-18 Threaded Spacer 5B

Refer to Drawing 5A

A. Study the drawing for proper orientation of the assembly of the elevator bell crank #122-29. Install one

#0107 M3 x 6 threaded ball onto the bell crank as shown. Install the #122-18 threaded spacer on the elevator

bell crank. Install one #0107 M3 x 6 threaded ball onto the stand off. Use Blue Loctite and tighten all

components securely.

B. As shown on the drawing, insert one #0099 M3 x 30 Phillips Bolt and one #0003 M3 Washer into the

appropriate hole for the elevator bell crank on the left main frame #122-15. On the inside of the left frame

slide one #0597-2 Brass Spacer, followed by the #122-29 Elevator Bell Crank assembly, and one #0597-1

Brass Spacer.

C. Position the #123-30 Right Main Frame onto the #0099 Phillips Bolt in the Elevator Bellcrank assembly.

Lightly secure in place with one #0003 M3 Washer and #0019-1 M3 Low Profile Locknut.