Instruction manual

Step 2: Installing the Right Main Frame

Parts Required: Bag #

1 #0064 M3x8 Button Head Socket Head Bolt 5C

9 #0061 M3x8 Socket Head Bolt 5C

4 #0063 M3x10 Socket Head Bolt 5C

2 #0019 M3 Locknut 5C

2 #0089 M3x10 Hex Head Bolt 5C

3 #0060-1 M3x6 Socket Head Bolts 5C

1 #0169 Bell Crank Pivot Stud 5C

1 #106-41 Canopy Standoff 5C

1 #122-27 Rear Canopy Hex Spacer Mount 5C

2 #0009 M3 Washers 5C

Refer to Drawing #5B

NOTE: Use Blue Loctite on all hardware except the #0019 M3 Locknuts and corresponding Socket Head Bolts.

Do not fully tighten until all components have been installed.

A. Install one #0169 Bell Crank Pivot Stud into the #115-20 Frame Spacer opposite the #0169 Bell Crank Pivot

Stud in the left main frame.

B. Install two #0063 M3x10 Socket Head Bolts into the #120-12 Upper Shaft Bearing Block.

C. Install one #0089 M3x10 Hex Head Bolt and one #106-41 Canopy Standoff opposite the Canopy Standoff

installed in the left main frame.

D. Install one #0089 M3x10 Hex Head Bolt and one #122-27 Rear Canopy Hex Spacer Mount into the upper

hole in the Rear Channel #115-10.

E. Install one #0061 M3x8 Socket Head Bolt and one #0019 M3 Locknut into the fourth hole down in the #115-

10 Rear Vertical Channel.

F. Install two #0061 M3x8 Socket Head Bolts into the rear two pem nuts in the Horizontal Front Channel #115-

24.

G. Install two #0060-1 M3x6 Socket Head Bolts and two #0009 M3 Washers into the CNC Machined

Swashplate Guide Block #122-29.

H. Install one #0061 M3x8 Socket Head Bolt and one #0019 M3 Locknut into the fourth hole up in the Front

Vertical Channel #115-12. Temporarily install one #0063 M3x10 Socket Head Bolt into the fifth hole up of

the Front Vertical Channel. Do not tighten this bolt.

I. Install one #0060-1 M3x6 Socket Head Bolt, one #0061 M3x8 Socket Head Bolt, and one #0064 Button

Head Socket Bolt onto the #120-8 Main Shaft Tail rotor Drive Bearing Block.

J. Install one #0061 M3x8 Socket Head Bolt and one #0063 M3x10 Socket Head Bolt into the #115-18 Lower

Main Shaft Block. Do not fully tighten the #0063 bolt.

K. Install three #0061 M3x8 Socket Head Bolts into the three #115-20 Frame Spacers.