Instruction manual

VI. BUILDING AND INSTALLING THE LANDING GEAR

Bags Required: #6A and #6B

Tools or Materials Required:

M2.5 Allen tool

Small Phillips screwdriver

Hand drill with 2.35mm (3/32@) drill

Small hammer

Slow Cyanoacrylate glue (CA)

M5.5 (7/32@) wrench

Tape

Installing Landing Gear Braces and Struts

Parts Required: Bag #

6 #0003 M3 Flat Washer (large) 6B

8 #0019 M3 Hex Locknut 6B

4 #0065 M3x12 Socket Head Bolt 6B

4 #0075 M3x25 Socket Head Bolts 6B

2 #0151 Black Strut 6A

2 #122-39 Titanium Skid 6A

4 #0153-1 Plastic Skid Cap 6B

2 #115-40 Black Machined Aluminum Landing Gear Mount 6B

1 #123-41 Lower Frame Plate 6A

4 #0058-1 M4 x 6 Hollow Point Set Screw 6B

4 #0061 M3x8 Socket Head Bolt 6B

1 #122-86 Support Block 6B

Refer to Drawings #6A

and #6B

A. Select four #0003 M3 Large Flat Washers, four #0019 M3 Hex Locknuts, four #0075 M3x25 Socket Head

Bolts, two #0151 Struts, one #123-41 Lower Frame Plate, and two #115-40 Machined Aluminum Landing

Gear Mounts.

B. Examine the drawing and note the orientation of the parts to be attached to the strut. As noted, install one

#115-40 Machined Aluminum Landing Gear Mount, one #123-41 (the front side) Lower Frame Plate, two

#0003 M3 Washers, two #0019 M3 Hex Locknuts, and two #0075 M3x25 Socket Head Bolts. Do not fully

tighten the bolts to allow alignment later. Repeat the steps for the remaining strut. Use the slots in the rear

side of the #123-41 Lower Frame Plate.

C. Install one #122-86 Support Block into the frames using two #0061 M3x8 Socket Head Bolts. Use Blue

Locktite. Tighten securely after step D.