Instruction manual

35
enough to allow adjustment.
D. Select both halves of the #0548-5 Fan Shroud and two #0029 M2.2x13 Phillips self-tapping screws. Examine
the drawing and slide each half of the shroud in position between the previously installed braces. While
loosely sitting within the frames, install the two #0029 screws (one front and one rear, from the left side) to
hold the shroud halves together. Take this opportunity to align all the braces and shroud mounting holes
visually and check for any clearance issues as described at the beginning of this assembly sequence Step 4. If
needed, the #0032 M2.9x9.5 Phillips self-tapping screws and the #0060-1 M3x6 Socket Head Bolts that
secure each corner of the shroud to each brace can be utilized to assist in positioning the shroud while
checking clearances. When you are satisfied with the fit of the shroud, select and install the remaining three
#0029 M2.2x13 Phillips screws and (if not already utilized) the two #0032 M2.2x9.5 Phillips screws and two
#0060-1 M3x6 Socket Head Bolts in the rear of the fan shroud, as shown in the drawing, leaving any screws
in the braces loose for adjustment. Align the shroud using the following criteria: the shroud should have
approximately equal clearance above and below the fan and should be centered horizontally around the fan
hub/clutch driver assembly. Tighten all brace to frame bolts and the two #0032 shroud to brace screws as well
as the two #0060-1 Socket Head Bolts. Later, should you wish to remove the shroud (all or half) the Abrace to
frame@ bolts need not be loosened again. This greatly simplifies later servicing.