Instruction manual

The following table will indicate the Servo Number, Frame Position, Receiver Connection, and Model Connection:

Servo Number Frame Position Receiver Connection Model Connection

1 Top of Right Frame Elevator Rear Bellcrank

2 Second from Top of Left Frame Aileron Left Front Bellcrank

3 Third from Top of Right Frame Pitch Right Front Bellcrank

4 Fourth from Top of Left Frame Rudder Rudder Bellcrank

5 Fifth from Top of Right Frame Throttle Carburetor

Table 2: Servo Location and Installation

Examine the drawings and be sure to mount each servo in the correct front/rear orientation.

Do not install any servo arms at this time.

B. Select your battery pack (flat type/1400 ma or greater preferred). Apply two strips of thick foam tape and

fasten the battery squarely on the #115-28 Radio/ Battery plate (evenly spaced between the Velcro). Wrap the

Velcro firmly across the battery.

C. Wrap your receiver in dense foam. We suggest the MA USA radio installation kit p/n #3051 which includes a

foam tube which fits the receiver very nicely. Leave an opening for the servo wiring. Set the prepared

receiver atop the battery and secure with the #115-30B Velcro strap (the strap is to be inserted through the

slots provided in the plate on either side of the battery).

D. Install the switch into the #115-62 Switch Plate, taking care to center the switch so there can be no contact in

either the ON or OFF position.

E. Install the gyro following the manufacturer=s instructions. Examination of the left and/or right frame will

reveal two horizontal slots on each at the very front. Velcro strips #115-30A are provided to secure any

component such as the gyro amplifier or governor to either side frame. Always use thick two-sided tape in

addition to the Velcro.

F. Make all necessary servo, gyro and switch connections in an orderly manner, routing wires to avoid contact

with frame edges and moving parts. Use the #0389 (single servo wire) and #0390 (two servo wires and/or

gyro wires) Wire Retainers to secure the wiring. These items will press onto the head of any M3 socket head

bolt. The bolts retaining the uppermost #115-20 Hex Frame Spacer are ideal positions to install #0389 for

Servos #1 and #2. Bolts retaining the gyro mounting brackets are suitable positions for #0390 retainers.

G. Remote base loaded antennas (such as MA USA p/n #4623 for 72 MHz.) are recommended. The Astick-on@

types are preferred and provision is provided for mounting this type on the right side frame just in front of

Servo #1. Do not bundle the antenna lead wire with itself or other wires. Aim the antenna straight forward

and curve as needed to clear the canopy inner surface.