Instructions for use
- Homemade solutions are not re-
commended in the de-scaling of this
appliance, such as the use of vinegar.
Anomalies and repair
- Take the appliance to an authorised
technical support service if problems
arise.
Do not try to dismantle or repair
without assistance, as this may be
dangerous.
- If the connection to the mains has
been damaged, it must be replaced
and you should proceed as you would
in the case of damage.
If any anomaly is detected, check the
following table:
Anomaly Possible cause Solution
Water comes out
from the side of the
filter holder
- The filter holder is not
correctly fitted.
- The edge of the ladle is
covered with coffee.
- The dispensing assem-
blage is dirty.
- See “obtaining coffee”
section
- Clean the ladle around
the edge and clean the
coffee supply assemblage.
- Clean with a damp cloth.
No coffee is dis-
pensed.
- There is no water
- The vacuum tube does
not reach the bottom of
the tank or is not correctly
fitted.
- The holes in the ladle
are blocked, the coffee is
too finely ground or has
been pressed too firmly.
- Refill the water tank.
- Position the vacuum
tube in such a way that it
reaches the bottom of the
water tank. Make sure it
does not become pinched.
- Empty the ladle and
clean with water. Clean
the dispensing assemblage
with a damp cloth. Reload
the ladle and lightly press
down the coffee.
The coffee comes
out slowly or in drips
- The coffee is too finely
ground or too firmly
pressed.
- Make sure the size of the
grounds is correct and that
it has not been excessively
pressed down.
0DQXDO0LQLPRNDLQGE
21