User manual

MWGAR/MWGARB User Manual

Version: 2.0

2 Installation

2.1 Hardware Installation

Step 1: Place the Wireless LAN Broadband Router to the best optimum

transmission location. The best transmission location for your WLAN

Broadband Router is usually at the geographic center of your wireless

network, with line of sign to all of your mobile stations.

Step 2: Connect the WLAN Broadband Router to your wired network. Connect

the Ethernet WAN interface of WLAN Broadband Router by category 5

Ethernet cable to your switch/ hub/ xDSL modem or cable modem. A

straight-through Ethernet cable with appropriate cable length is needed.

Step 3: Supply DC power to the WLAN Broadband Router. Use only the AC/DC

power adapter supplied with the WLAN Broadband Router; it may occur

damage by using a different type of power adapter.

The hardware installation finished.

2.2 Software Installation

 There are no software drivers, patches or utilities installation needed, but

only the configuration setting. Please refer to chapter 3 for software

configuration.

Notice: It will take about 55 seconds to complete the boot up sequence

after powered on the WLAN Broadband Router; Power LED will

be active, and after that the WLAN Activity LED will be flashing to

show the WLAN interface is enabled and working now.