Owner`s manual

AVP INSTRUCTIONS E
10
AVP FRONT PANEL
The following numbers refer to the numbers located
on the drawing of the Front panel of AVP on page 2 of
this manual.
1 - ROTARY ENCODER :
Provides the following functions :
♦ Master Volume Control.
♦ Channel trimming.
♦ Delay time adjustment.
♦ Input name assignment
♦ Mode selection
2 - DISPLAY :
The display indicates
♦ In Normal Mode :
• On the left side the selected source.
• On the right side the volume level.
♦ In Test Mode :
• The relative level of each channel in
sequence.
♦ In Adjust Mode :
• The relative level of each channel.
3 - STANDBY LED :
The Led indicator is On when the unit is in Standby.
4 - INPUT KEY:
To switch between the different inputs.
5 - STEREO KEY:
To force the reproduction in Stereo mode
6 - DTS LED :
The Led indicator is On when the unit has detected
DTS.
7 - DOLBY DIGITAL LED :
The Led indicator is On when the unit has detected
DOLBY DIGITAL signal.
8 - PRO-LOGIC LED :
The Led indicator is On when the unit has detected
DOLBY PRO-LOGIC signal.
.
9 - MPEG LED :
The Led indicator is On when the unit has detected
MPEG Multichannel signal.
10 - MODE KEY:
To access the configuration menus.
To access the trimming function for each output.
To access In session trimming.
AVP FRONT PANEL (Continue)
11 - STANDBY KEY:
To switch the unit in and out of Standby mode.
SYSTEM POWER-UP
After having turned on the ON/OFF switch located
at the rear of the unit press the STANDBY key of the
unit or the AVP key of the Minium system remote
control handset to bring AVP into operational mode.
If you are using a Minium AMP as main amplifier
for the front speakers, you should turn it on now and
put it in Processor mode. (Refer to Minium AMP
owner's manual for this operation).
If you have chosen to turn on AVP with the AVP
key of the remote control handset, and you are using
a Minium AMP as main amplifier, the Minium AMP
has automatically recognised the command and is
now indicating alternatively Au2 In / Pro Y. You should
confirm your request by pressing again on the AVP
key of your Minium remote control handset. Minium
AMP is now indicating "Pro on" in fixed mode.
If you have decided to use another type of
amplifier for the front speakers you should turn on this
amplifier now.
AVP Display now indicates :
and after a few seconds:
if there is no signal on the CO-1 input.
With AVP being fully remote controlled, the use of
the remote control handset will ease all operation and
allow you to make more accurate adjustment as you
will be able to do them from your listening position
without having to move back and forth to your
equipment.
The TEST key is the only key that do not have a
corresponding key on the remote control handset.
This has been done on purpose in order to avoid to go
into the test mode by accident.
However for the few first steps of the AVP
configuration it is easier to use the keys and the rotary
encoder directly on the unit itself.
The remote control handset will be mostly useful
when you will need to make adjustment in real time.
Off course, in normal use, the remote control
handset will be always more convenient to control
AVP from the center of the viewing area.
CO1 UNLOC
CO1 - 30dB