Owner`s manual

AVP INSTRUCTIONS E
11
SYSTEM CONFIGURATION
You are now going to configure AVP to match your
actual equipment.
The following represent a typical room layout for
5-channel sound.
Before you start with AVP configuration we have
made a little chart to help you define the parameters
required by AVP to adapt to your system. You must fill
in the boxes below depending upon you system
configuration and after having fully completed the
information required you will then proceed with the
configuration.
SYSTEM CONFIGURATION (Continue)
You are now ready to start configuring AVP. Press
on the MODE key until the display is indicating:
If your system is fitted with an amplified Sub-
Woofer, turn the rotary encoder and the display will
then indicate:
AVP is now set for Sub-woofer operation.
Press on the Mode key again. The display now
indicates:
If you DO NOT HAVE a center speaker, turn the
rotary encoder and the display will indicate:
AVP is now set for Phantom mode operation.
Press on the Mode key again. The display now
indicates:
If you DO NOT HAVE Surround speakers, turn the
encoder and the display will indicate:
AVP is now set for 3-STEREO mode operation.
You must enter now the measured distances from
the center of the viewing area to each of the speakers
of your system. AVP is set-up in such a way that it is
assumed that DIM-F is equal for left and right Front
speakers.
AVP will only ask you to enter the distances of the
speakers that are present in your system. If you DO
NOT HAVE a center speaker DIM-C is irrelevant.
SUB YES
SUB NO
CENT YES
SURR YES
CENT NO
SURR NO
VIDEO SCREEN
L
C
LS RS
R
VIEWING AREA
DIM C DIM F DIM F
DIM LS
DIM LR
IS YOUR SYSTEM EQUIPED WITH?
FROM YOUR ROOM LAYOUT WHAT ARE THE
FOLLOWING DISTANCES IN METERS?
AMPLIFIED SUB-WOOFER
YES NO
CENTER SPEAKER
YES NO
SURROUND SPEAKERS
YES NO
DIM F = ______m
exemple : 2.5m or 3.8m
DIM C = ______m
DIM LS = ______m
DIM RS = ______m