Instructions / Assembly

Table Of Contents

WARNING:

All of the parts, hardware and components such as the

hanger bracket and hanger ball have been provided for your safety and the

proper installation of your new ceiling fan. The use of other parts,

hardware or components not supplied by Minka Aire

with the fan will

void the Minka Aire

Warranty.

REMEMBER

to turn off the power. Follow the steps below to hang your

fan properly:

Step 1. Secure the hanger bracket to the ceiling outlet box using the screws

provided with your outlet box in conjunction with the lock-washers

provided with the fan. (Fig. 5)

Step 2. Loosen the two set screws and remove the hitch pin and lock pin

from the coupling located on the top of the motor assembly. (Fig. 6)

Step 3. Remove the hanger ball from the downrod assembly by loosening

the set screw and removing the cross pin. (Fig. 7)

Step 4. Carefully feed fan wires up through the downrod. (Fig. 8) Thread

downrod into the coupling until the holes are lined up and secure with

the lock pin and hitch pin previously removed, tighten set screws. (Fig. 9)

NOTE:

This fan comes with a 6” downrod. In addition you have been

provided with a wire harness which you can attached to the fans wiring

should you need to use a longer downrod. Please refer the owner's

manual included with the extension cord packge.

Step 5.Slip coupling cover, canopy cover and canopy onto downrod.

Carefully reinstall the hanger ball onto the downrod being sure that it's

properly positioned over the cross pin and the wires are not twisted,

tighten set screw. Place downrod rubber cover onto the hanger ball (Fig. 9)

Step 6. Lift the motor assembly and place the hanger ball into the

hanger bracket. rotate the motor assembly as needed until the check

groove from the hanger ball rests firmly over the registration tab from

the hanger bracket. Motor assembly should not rotate if this is done

correctly. (Fig. 10)

HANGING THE FAN